The EDT directION Perchlorate Half Cell ion selective electrode has a solid state PVC polymer membrane. It requires the use of a double junction reference electrode which has its outer chamber filled with the Ionic strength adjustment buffer (ISAB) detailed below.

  • Solid State Electrode
  • No internal Filling solutions required
  • Rugged Robust and Maintenance free
  • Waterproof and Submersible
  • Fixed or Detachable lead versions
  • Compatible will all pH or Ion meters
  • Long life and Low Cost

The electrode is designed for the detection and analysis of Perchlorate ions in aqueous solutions and is suitable for use in the laboratory and in on line analyzers.

Please note that both the ISE and the reference electrode need to be placed in the standards or samples simultaneously and should not be more than around 10cm apart. The side filling cap of the double junction reference electrode should be open during measurements and closed during storage.

The EDT Half Cell ISE can be used immediately but pre-soaking for 5 minutes in a 100 ppm Perchlorate solution along with the double junction reference electrode is recommended. The ionic strength of the standards and solutions should be kept constant between all standards and samples. This is achieved by the simple addition of an Ionic strength adjustment buffer (ISAB). Lithium Acetate is ideal. A typical addition would be 2 ml of 1 molar ISAB to 100 ml of standard and sample.

This solution is also used as the outer chamber reference electrode filling solution. For low level measurements below around 50 ppm in relatively pure samples no ISAB is needed. No temperature correction is possible it is therefore important that all standards and samples should be measured at the same temperature to ensure that temperature effects are eliminated. Begin calibration from the lowest concentration standard to avoid cross contamination. Calibration should cover the anticipated range of the samples.

Rinse tips of both electrodes with de-ionised water between measurements and dab off excess water. Avoid strongly acidic or alkaline samples, strong detergents and organic solvents.

To see a simple calibration click here. EDT directION produce a full range of Stock Standards and Ionic Strength Adjustment Buffers (ISABs) to save valuable time and give confidence in the quality of your results.

Thumb File information
1061 Perchlorate Half Cell ISE Brochure.pdf 1.75MB 129
Accessories
Cable length 1000mm
Cap Diameter 16mm
Commodity Code 90279050
Concentration Range 0.2-99,500 ppm
Connector BNC
Diameter 12mm
Endpoint time Typically 10-60 seconds
Interferences Iodide, Thiocyanate, Nitrate
length 155mm
pH range 0-11pH
Potential Drift 2mV per Day
Resistance at 25 Deg C < 2.5 MOhm
Temperature range 5-50 Degrees C

Write a review

Note: HTML is not translated!
    Bad           Good

Perchlorate Half Cell ISE

  • £195.00


Related Products

Perchlorate Combination ISE

Perchlorate Combination ISE

Here are some of the benefits of using EDT directION Selective Electrodes: Rugged Solid State S..

£295.00

Perchlorate Half Cell ISE

Perchlorate Half Cell ISE

The EDT directION Perchlorate Half Cell ion selective electrode has a solid state PVC polymer membra..

£195.00

Direct Readout Bench pH/Ion Meter & Accessories

Direct Readout Bench pH/Ion Meter & Accessories

The DR359Tx is a straightforward Ion Meter with the ability to measure Ion concentration using up to..

£670.00

We deliver to all countries worldwide

For International orders call our sales hotline on +44 (0) 1304 829960