EDT directION manufacture a range of conductivity calibration solutions to enable the successful and accurate calibration of our conductivity meters and electrodes.

The measurement of conductivity requires that the sample be aqueous and to be of adequate volume to cover the electrode surfaces. It is important that if the samples and standards are not of the same temperature then temperature compensation is required.

Conductivity increases approximately 2% per degree centigrade. Normally the conductivity calibration is carried out on one point. One useful check is that the conductivity in air should be zero as there is no conductive material between the electrodes.

EDT direction conductivity standards are Potassium Chloride solutions in either 100ml or 500ml sealed plastic bottles. For correct use the appropriate volume of standard should be poured into a clean beaker or container. Do not calibrate by placing the conductivity cell in the bottle as this will contaminate the solution. Following calibration remember to close the bottle to avoid evaporation or contamination and do not pour the used standard back into the bottle.

To view a simple calibration click here.

Thumb File information
Conductivity Calibration Solutions .pdf 413.33KB 484
MSDS CONDUCTIV ITY STANDARD 12880 A3056.pdf 1.37MB 783
Accessories
Commodity Code 25010051
Diameter 75mm
Filled Weight 510g
Graduations 50ml
Height 170mm
Inner Seal Yes. Transportable.
Material Polypropylene (PP)
Volume 500ml

Write a review

Note: HTML is not translated!
    Bad           Good

Conductivity Calibration Solution 12.88mS/cm 500ml

  • £20.00



Recommended Essentials

Glass Conductivity Cell K=1 £86.00 Glass Conductivity Cell K=1 (£86.00)
Conductivity Calibration Solution 12.88mS/cm 100ml £10.00 Conductivity Calibration Solution 12.88mS/cm 100ml (£10.00)

Related Products

Basic Bench Conductivity Meter & Accessories

Basic Bench Conductivity Meter & Accessories

The EDT BA380 Basic Conductivity meter is robust, easy to operate and is designed to give results th..

£375.00

Conductivity Calibration Solution 12.88mS/cm 100ml

Conductivity Calibration Solution 12.88mS/cm 100ml

EDT directION manufacture a range of conductivity calibration solutions to enable the successful and..

£10.00

Glass Conductivity Cell 12mm K=1

Glass Conductivity Cell 12mm K=1

The E8071 Glass Conductivity Cell is for general purpose dip applications and is ideal for general l..

£86.00

Series 4 Portable Combined pH and Conductivity/TDS Meter KIT

Series 4 Portable Combined pH and Conductivity/TDS Meter KIT

The QP458 Portable combined pH and Conductivity meter is the third in a series of Quality Portable m..

£595.00

Epoxy Conductivity Dip Cell K=1 Mini DIN Connector

Epoxy Conductivity Dip Cell K=1 Mini DIN Connector

The E5010 Epoxy Conductivity Cell is for general purpose dip applications and is ideal for general l..

£175.00

We deliver to all countries worldwide

For International orders call our sales hotline on +44 (0) 1304 829960