EDT directION manufacture a range of conductivity calibration solutions to enable the successful and accurate calibration of our conductivity meters and electrodes.

The measurement of conductivity requires that the sample be aqueous and to be of adequate volume to cover the electrode surfaces. It is important that if the samples and standards are not of the same temperature then temperature compensation is required.

Conductivity increases approximately 2% per degree centigrade. Normally the conductivity calibration is carried out on one point. One useful check is that the conductivity in air should be zero as there is no conductive material between the electrodes.

EDT direction conductivity standards are Potassium Chloride solutions in either 100ml or 500ml sealed plastic bottles. For correct use the appropriate volume of standard should be poured into a clean beaker or container. Do not calibrate by placing the conductivity cell in the bottle as this will contaminate the solution. Following calibration remember to close the bottle to avoid evaporation or contamination and do not pour the used standard back into the bottle.

To view a simple calibration click here.

Thumb File information
Conductivity Calibration Solutions .pdf 413.33KB 489
MSDS Conductivity Standard A3053.pdf 1.35MB 740
Accessories
Commodity Code 25010051
Contents Analytical Grade Potassium Chloride and Deionised Water
Diameter 75mm
Filled Weight 510g
Graduations 50ml
Height 170mm
Inner Seal Yes. Transportable.
Material Polypropylene Graduated Bottle.
Volume 500ml

Write a review

Note: HTML is not translated!
    Bad           Good

Conductivity Calibration Solution 1413µS/cm 500ml

  • £20.00



Recommended Essentials

Glass Conductivity Cell K=1 £86.00 Glass Conductivity Cell K=1 (£86.00)
Conductivity Calibration Solution 12.88mS/cm 100ml £10.00 Conductivity Calibration Solution 12.88mS/cm 100ml (£10.00)

Related Products

Epoxy Conductivity Dip Cell K=1

Epoxy Conductivity Dip Cell K=1

The A5010 Epoxy Conductivity Cell is for general purpose dip applications and is ideal for general l..

£175.00

Flexible Electrode Holder and Stand

Flexible Electrode Holder and Stand

The E8060 is a strong flexible electrode stand with a sprung arm and a cast base for stability.The h..

£82.00

Glass Conductivity Cell 12mm K=1

Glass Conductivity Cell 12mm K=1

The E8071 Glass Conductivity Cell is for general purpose dip applications and is ideal for general l..

£86.00

Conductivity Low Volume (200 microlitre) Flow Cell with ATC

Conductivity Low Volume (200 microlitre) Flow Cell with ATC

The A6000/ATC Polymer Bodied Conductivity Cell is for continuous flow applications and is ideal for ..

£350.00

Glass Conductivity Cell K=0.1 Mini DIN Connector

Glass Conductivity Cell K=0.1 Mini DIN Connector

The E8075 Glass Conductivity Cell is for dip applications where the sample conductivity is low and t..

£89.00

Glass Conductivity Cell K=1 Mini DIN Connector

Glass Conductivity Cell K=1 Mini DIN Connector

The E8074 Glass Conductivity Cell is for general purpose dip applications and is ideal for general l..

£86.00

We deliver to all countries worldwide

For International orders call our sales hotline on +44 (0) 1304 829960