EDT directION manufacture a full range of standards, filling solutions and Ionic Strength Adjustment Buffers (ISABs).

All ISE measurements require calibration using typically two standards plus the addition of an ISAB. Details of the type and concentration of standards and ISABs can be found in both the ISE instruction manual or the Application sheet where published.

Ionic Strength Adjustment Buffers (ISAB) are required for accurate Ion analysis using Ion Selective Electrodes (ISEs).

The EDT Calcium ISAB has been specially formulated to allow the buffering of all samples and standards to the same Ionic Strength without interfering with the Calcium measurement. The Calcium ISAB comes in 500ml leak-proof bottles with an inner seal. Typical addition is 2ml of ISAB to every 100ml of standard and sample.The ionic strength of standards and samples are not the same thereby the ability of ions to freely move around varies from sample to sample. This means that the effective activity of ions will vary between these solutions.

ISEs measure activity as they can only sense ions that come into contact with the sensor surface.To ensure all ions have an equal probability of contacting the ISE the total Ionic Strength of all solutions should be equal (or as close as possible). This is achieved by adding a small volume of ISAB (Ionic Strength Adjustment Buffer) to a fixed volume of all standards and samples.

Each ISAB is carefully selected for each different ISE to ensure that the added ions do not interfere with the measurement but do have sufficient concentration to increase the overall Ionic strength to the desired level without diluting the solutions significantly.

Application methods available from EDT directION are available.Specialist ISABs can also be used to equalize pH or remove interferents as required.

For advice on these applications please contact our technical support team sales@edt.co.uk 



Thumb File information
MSDS Calcium Ionic Strength Adjustment Buffer (500ml).pdf 1.41MB 433
ISAB Brochure.pdf 1.78MB 673
Accessories
Commodity Code 38220000
Diameter 75mm
Filled Weight 510g
Graduations 50ml
Height 170mm
Inner Seal Yes. Transportable.
Material Polypropylene (PP)
Volume 500ml

Write a review

Note: HTML is not translated!
    Bad           Good

Calcium Ionic Strength Adjustment Buffer (ISAB) 500ml

  • £25.00


Related Products

Calcium Flowcell ISE

Calcium Flowcell ISE

ISE Flowcells from EDT directION are solid state, zero dead volume sensors that can be used independ..

£305.00

Calcium Combination ISE

Calcium Combination ISE

Here are some of the benefits of using EDT direction Combination Ion Selective Electrodes: Rugg..

£305.00

Calcium Flow Plus Combination ISE

Calcium Flow Plus Combination ISE

The EDT directION Flow plus range incorporates two solid state ISE’s in one 12 mm Epoxy body. One a..

£405.00

Calcium 1000ppm Standard Solution 500ml

Calcium 1000ppm Standard Solution 500ml

EDT direction produce a wide range of stock standards to ensure that ISE calibration is both simple,..

£15.00

Calcium Flow Plus Filling Solution 30ml

Calcium Flow Plus Filling Solution 30ml

Filling solution for use with the 5041 Calcium Flow Plus ISE.Solution supplied in a 30ml bottle..

£15.00

Calcium Mini ISE

Calcium Mini ISE

EDT directION mini Ion selective electrodes are rugged solid state sensors that can be used inconjun..

£105.00

Calcium Combination ISE With 3 Metre Cable/BNC

Calcium Combination ISE With 3 Metre Cable/BNC

Here are some of the benefits of using EDT direction Combination Ion Selective Electrodes: Rugg..

£330.00

We deliver to all countries worldwide

For International orders call our sales hotline on +44 (0) 1304 829960